In this module, you will run calculations on a structural model and review the analysis, as well as perform design calculations for steel and reinforcement elements in the model.

This module takes approximately 20 minutes to complete. By the end of the module, you should be able to:

• Run static analysis and review the results of the analysis
• Perform steel design for selected elements
• Calculate slab reinforcement for selected elements

About the author

This module was created by Pawel Pulak, Designated Support Specialist at Autodesk.

Before you start

• Please make sure you have the Revit and Robot software loaded.
• If you have technical difficulties, please reach out to product support.