Once you have performed structural analysis in Robot, you can modify the Revit model with the information. In this module, we will change member sizes in Revit using Direct integration with Robot and then update the Revit model with results from Robot and use the Results Explorer to review the analysis.

This module takes approximately 15 minutes to complete. By the end of the module, you should be able to:

• Change member sizes in Revit using Direct integration with Robot
• Review results of analysis in Robot using the Results Explorer in Revit

About the author

This module was created by Pawel Pulak, Designated Support Specialist at Autodesk.

Before you start

• Please make sure you have the Revit and Robot software loaded.
• If you have technical difficulties, please reach out to product support.