• Up next:Introduction
Professional | ~15 min.
Annotate and Share 3D Models
Module | Outcomes and capabilities

In this module, you will learn how to annotate a model, share it, analyze tolerance and relationships in an assembly, and then share the annotation.

This module takes approximately 15 minutes to complete. 

Module pre-requisites

This module requires user-level knowledge of Inventor and is focused on best practices and its industry applications. If you don't have experiences with this product, we recommend you to take foundational training using one of the resources below:

About the author

This module was created by Thom Tremblay.

Before you start

  • Please make sure you have the Inventor software loaded.
  • If you have technical difficulties, please reach out to product support
Download resources
  • Up next:Introduction