Module

15 min.

Tolerance analysis

Module overview

Learn to set up tolerance analysis, validate the settings, set up an analysis using the assembly constraints, modify the tolerances, and then compare results.

This content series takes approximately 15 minutes to complete. 

Prerequisites

This content series requires user-level knowledge of Inventor and is focused on best practices and its industry applications. If you don't have experiences with this product, we recommend you to take foundational training using one of the resources below:

About the author

This content series was created by Thom Tremblay.

Before you start

  • Please make sure you have the Inventor software loaded.
  • If you have technical difficulties, please reach out to product support. 

Module downloads

These downloadable resources will be used to complete units in this module:

Module outline